Skinnova Application Instructions

image

Clean your device thoroughly of all the dust and facial oils. Peel a Skinnova piece from its backing.

image

Position the skin slightly above the device, without letting the sticky side touch the device, and align it perfectly. Use the edges, camera holes and other cut outs to judge alignment ensuring they are perfectly centered before laying down the skin. Once statisfied with the alignment, let the skin adhere on the device.

If you are unsatisfied with the alignment,carefuly remove the skin, without stretching it, and align it again. Alignment is the most important aspect for a perfect finish.

image

Once you have confirmed the alignment after placing, press down the skins against the device. Push air bubbles, if any, starting from the center towards the nearest edges.

image

For corners and sides, we recommend using a hair dryer on moderate setting to warm those portions of the skin and push them down on the device using your thumb. Repeat this procedure even for the edges so that they stay in place.

Tip : For a perfect look, you may have to heat and extend the side strips to close the gaps between the adjoining pieces.

image

Make sure all the corners and edges are lying flush with the surface of your device. Press down the corners firmly against the device and hold for 25-30 secs using your thumb. If any of the corners are still lifting, repeat step 4 on those areas.

Important Tips - Front Skin Installation

image

While the front skin is still on the paper liner, peel a small corner portion of the skin from the center screen area and bend it. DO NOT peel the entire screen skin.

image

Apply the front skin on the device using the same procedure as the back skin.

image

After applying, peel off the center screen area starting from the bent corner.

Center Screen Shield Application Instructions (without Spray)

These instructions are ONLY for applying the clear center screen shield that comes with Skinnova™. DO NOT use these instructions to apply your skinnova skins or any other Gadgetshieldz™ product. Identify a well lit and dust-free location for installation away from any wind and sunlight. Application Solution : Make a soap solution in a shallow dish by mixing 1-2 drops of Jhonsons baby shampoo (or any mild liquid hand wash soap) and around 300 ml (12 oz) of water.
image

SWITCH OFF your device. Wash your hands and clean the device’s screen surface throughly of all the dirt with the microfiber cloth.

image

Wet all your fingers with the SPRAY SOLUTION and starting from a corner, slowly remove the screen shield.

image

Dip the removed piece into the soap solution completely so that the entire shield is wet and then remov all the excess solution by sliding your fingers along the shield.

image

With the adhesive side facing down, place the screen shield on the center screen area as closely aligned as possible. If the shield is enough wet, you can glide it into the correct position with minor adjustments using your fingers.

image

Once satisfied with the alignment, cover the application squeegee with the microfiber cloth and remove the excess solution under the film towards the edges and away from any open ports like speakers, microphone etc.

image

Once all the portions are applied, keep your device SWITCHED OFF for a period of 1 or 2 HOURS to let the film set. HAZINESS and BUBBLES are expected immediately after the installation. The appearance will improve remarkably over a 24-48 Hrs period with the moisture drying out and micro bubbles, if any, working themselves out in 1 - 2 DAYS.

Welcome to Gadgetshieldz